- Industria: Government
- Number of terms: 22108
- Number of blossaries: 0
- Company Profile:
A type of solar photovoltaic device made in a continuous process of pulling material from a molten bath of photovoltaic material, such as silicon, to form a thin sheet of material.
Industry:Energy
A type of solar heating system that circulate warm water from storage through the collectors and exposed piping whenever freezing conditions occur; obviously a not very efficient system when operating in this mode.
Industry:Energy
A type of radiant heating system where the radiator is located along an exterior wall where the wall meets the floor.
Industry:Energy
A type of radiant heating system where the building floor contains channels or tubes through which hot fluids such as air or water are circulated. The whole floor is evenly heated. Thus, the room heats from the bottom up. Radiant floor heating eliminates the draft and dust problems associated with forced air heating systems.
Industry:Energy
A type of power inverter that produce a high quality (nearly sinusoidal) voltage, at minimum current harmonics.
Industry:Energy
A type of power generating facility that pumps water to a storage reservoir during off-peak periods, and uses the stored water (by allowing it to fall through a hydro turbine) to generate power during peak periods. The pumping energy is typically supplied by lower cost base power capacity, and the peaking power capacity is of greater value, even though there is a net loss of power in the process.
Industry:Energy
A type of photovoltaic device in which the electricity induced in the cell is used immediately within the cell to produce a chemical, such as hydrogen, which can then be withdrawn for use.
Industry:Energy
A type of photovoltaic cell made from a single crystal or a polycrystalline slice of silicon. Crystalline silicon cells can be joined together to form a module (or panel).
Industry:Energy
A type of passive solar heating system where heat is collected in one area for use in another.
Industry:Energy
A type of municipal solid waste (MSW) incineration facility in which MSW is burned with only minor presorting to remove oversize, hazardous, or explosive materials. Mass burn facilities can be large, with capacities of 3000 tons (2.7 million kg) of MSW per day or more. They can be scaled down to handle the waste from smaller communities, and modular plants with capacities as low as 25 tons (22.7 thousand kg) per day have been built. Mass burn technologies represent over 75% of all the MSW-to-energy facilities constructed in the United States to date. The major components of a mass burn facility include refuse receiving and handling, combustion and steam generation, flue gas cleaning, power generation (optional), condenser cooling water, residue ash hauling and landfilling.
Industry:Energy
